Making the Leafy Tree Vase - Part 1



For this next project I'm using a 6 in. tall sundae glass. I start by covering the entire surface with a dark brown clay.


Next I combine colors for these two blends - one for flower petals and the other for the leaves.


Making the petal cane - I cut the blend in fourths, flatten each fourth slightly and then arrange them side by side forming a squarish cane.


Next I cut the cane in half and put the two pieces side by side, doubling the number of stripes. I roll the cane, rounding the sides, and reduce it.


Here I'm assembling the leaf cane. First I reduce the cane into six equal portions, reduce each again and then place them side by side, pressing them together.


Next I cut it in half and add the center vein.


And now, to make the tree. First the glass is covered partially in a dark green. This green will serve as a base for the leaves.


Here the extruder is packed with a stack of dark green and brown. Once extruded, these pieces are curled slightly and pressed into place forming the trunk…

See Part 2 of this project here.

My Work is Featured on Polymer Clay Chameleon!


I first discovered the beautiful work of Eugena Topina early last year in a Fire Mountain Gems catalog. Her necklace Bridal Orchids was a contest finalist. There were no materials listed but I just knew it had to be polymer clay. Using the link in the catalog, I came to EugenasCreations.com. I was right, her work is polymer clay and some of the best I've seen!

And then on February 1st of this year, Eugena launched Polymer Clay Chameleon, a special blog featuring not her own work, but the work of other polymer clay artists who sold their art on Etsy.com. Reading about the various artists and their art became a part of my early morning routine. So you can imagine my surprise when yesterday that artist was me! Thank you so much Eugena!


My two favorite necklaces by Eugena - Sculpted Orchids and Wild Rose.




The Dragon Slayer - Part 1



For this next design I'm using a flat sided glass flask. I mix up about 5 oz. of a brownish clay and then shape the dragon and cut out his wings.


Adding veins. Using the upholstery needle I give the wings some texture. Next I use my rubber tipped clay shaper to make them look a bit folded.


Testing the fit - perfect!


And now for the scales - the really, really tiny scales. I cut each one, roll it round between my fingertip and thumb, press it onto the dragon making it flatter and finally give it a little impression at the top… talk about tedious, but the fine details are what makes this a fun design.


All covered in scales.


Now for his face - tiny horns, and eyes - even some little eye lashes!


All finished.


Shaping the shield. I stamp the surface with two different size jelly roll stamps for a smokey look.


The dragon's in place.


Making the rim.


The finished shield.


Detail.


Next I begin on the horse - legs are going everywhere, but I finally get him together!


Here's the finished horse - feathers and all. Next I begin on the knight. Shaping his helmet sure is hard but after about a dozen tries I get it right - it can only get easier!


Here I've made a tiny shield for my knight.


Next I make the horse's tack and put the knight in place , arming him with spear and shield.


Now it's time to work on the bottle. I begin with a layer of clay covering the surface and then sculpt the door and windows of the dragon lair.


Here I've put scales on the dragon's tail and added a vine and leafless tree - probably was scorched by the dragon's fire ;).


The front detail is almost finished - next I'll start on the back…

See part 2 of this project here.